Non Slip Additive

2 Reviews

$32.00

Clear
  • Cost For

    $25 per 20ltr

  • Re-Coat

    n/a

  • UV Stable

    n/a

  • Coverage

    n/a

  • Coats

    n/a

  • Equipment

    n/a

  • Dilution

    n/a

  • Clean Up

    n/a

Features

  • A fine slip-reducing additive for a variety of sealers and coatings, including:
  1. Right Choice 20L Clear Semi Gloss Wet Look Solvent Based Concrete Sealer
  2. Right Choice High Gloss Polyurethane Coating System
  • Improves safety under wet and dry conditions
  • An especially important additive for ‘wet’ surfaces
  • Easy to use with excellent slip resistance
  • Extremely abrasion resistant
  • The Clear Low Sheen Non Slip Additive imparts smooth, tumbled glass particles to the surface of floor sealing systems to create a safer, non-slip surface.

    Product Description

    Non Slip Additive is a fine slip reducing additive for a wide variety of sealers and coatings such as the Clear Concrete Sealer or Polyurethane Coating. Sealed concrete surfaces become slippery, particularly when wet, making conditions less safe for pedestrians and vehicles. The Right Choice Clear Low Sheen Non Slip Additive imparts smooth, tumbled glass particles to the surface of floor sealing systems to create a safer, non-slip surface. Particle sizes are 0.45mm – 0.62mm.

    Non Slip Additive is particularly useful around ‘wet surfaces’ including pools, factory loading docks, access ramps, stairs, entrance foyers and other public pedestrian and vehicle areas.

    Ideal For

    • Wet Areas
    • Exterior Pathways
    • Driveway’s
    • Garage Floors
    • High traffic areas
    • Pool surrounds
    • Factory loading docks
    • Stairs & ramps
    • Public pedestrian and vehicle areas

    Coverage Rates

    Theoretical Spread Rate (m2 per kg of non-slip additive)

    • Minimum = 5m2 per kg
    • Maximum = 10m2 per kg
    • Typical = 7m2 per kg

    Information Guides

    1. Download: Technical Data Sheet

    Suggested Application Method:

    Take small amounts of non-slip additive in your hand and throw high up into the air to allow the non-slip additive to land naturally in the 1st coat of sealer. Ensure to apply it to the 1st coat whilst the sealer is still wet, so apply as you go. Allow the 1st coat to dry and then roll the 2nd coat of sealer over it to lock the non-slip additive in.

    Specifications

    Product Name: Non Slip Additive

    Material: Crushed glass particles

    Pack Sizes: 1kg & 4kg

    2 reviews for Non Slip Additive

    1. Anastasia

      Easy to Use. Followed the instructions and turned out perfect!

    2. Tony Dwyer

      I think I used too much of this, probably only needed 1/2 a bag in the last coat of sealer. Seems too work very well.

    Add a review

    Your email address will not be published.